TM1 Rule error...
Posted: Mon Oct 03, 2011 4:14 pm
Hi,
When I use following TI function in TM1 rule editor, I get below attached error......
Function Used: CellPutProportionalSpread(7704,'GL','expense','Engineering','2011','Actual');
I am not sure whether I can use this function under rule editor or not? if yes, Am I using this function correctly?
Regards.
When I use following TI function in TM1 rule editor, I get below attached error......
Function Used: CellPutProportionalSpread(7704,'GL','expense','Engineering','2011','Actual');
I am not sure whether I can use this function under rule editor or not? if yes, Am I using this function correctly?
Regards.