Page 1 of 1
TM1/Rules
Posted: Thu Oct 21, 2010 5:02 pm
by Santiago
Hi all
I have a doubt. As I can do to make the left side of the cube rule can refer only to children of certain parent (consolidated) in one dimension. Also, as a reference on the left side of the rule to consecutive elements without having to list them all.
Thank you very much to all
Best regards
Re: TM1/Rules
Posted: Thu Oct 21, 2010 6:03 pm
by rkaif
Santiago wrote:Hi all
I have a doubt
To clear your doubts you need to read the Manual. Here is a link for you:
http://publib.boulder.ibm.com/infocente ... gTM1_.html
Re: TM1/Rules
Posted: Thu Oct 21, 2010 6:18 pm
by RTFM
rkaif wrote:Santiago wrote:Hi all
I have a doubt
To clear your doubts you need to read the Manual.
@Rizwan,
Did you actually try to understand the question?
@Santiago,
I'm not sure whether I understand your question - if you're wondering whether you can refer to a list of elements in the area definition of the rule by using a consolidated element, than the answer is no. But you can use f.i. the ElIsAnc fuction in the formula part of the rule to make the rule apply only to N level elements underneath a certain node.
Re: TM1/Rules
Posted: Sat Oct 23, 2010 3:00 pm
by Wim Gielis
RTFM wrote:rkaif wrote:Santiago wrote:Hi all
I have a doubt
To clear your doubts you need to read the Manual.
@Rizwan,
Did you actually try to understand the question?
And it's you who says this? With a username like that...
Santiago,
Use the elisanc, eliscomp, elispar functions. Or you attributes to decide what elements are affected.
Functions go on the right hand side of a rule, NEVER on the left hand side.
Wim