TM1 Forum

Hello again,

I have got to Cube (Cube A, Cube B)
The first Cube, Cube A is the same a Cube B minus a dimension.
So Cube A is (Dimension 1, Dimension 2, Dimension 3) and Cube B is (Dimension 1, Dimension 2, Dimension 3, Dimension 4)
I would like just to feed Cube B with Cube A and treat Dimension 4 equal to Dimension 3.
So I would like to have a B rule that does this: CubeB [Dimension 1, Dimension 2, Dimension 3, Dimension 4] = Cube A [Dimension 1, Dimension 2, Dimension 3]
where Cube B. Dimension3 is the same a CubeB dimension4 and equal to CubeA. Dimenson 3.
And CubeA dimension 1 = Cube B dimension 1
And CubeA dimension 2 = Cube B dimension 2

What I tried to do is to put this in the Cube A Rules Editor

FEEDERS;
[] => DB (Cube B, !Dimension 1, !Dimension 2, !Dimension 3, !Dimension 3)

But I dont know what to put as SKIPCHECK for the Cube B rules editor in order to activate this feeder (if I have understood properly the inter cube feeder process)


Any idea?


Thankx in advance for your time.

Bye

Nicola

Hi

Consider:

Thanxs a lot!!!
It was exactly what I was looking for


Bye
Nicola