TM1 Forum

Hi this is my first post in this forum. I have scanned through most of the posts and have found some valuable information so Thank you for that.

I am a TM1 developer and I would consider my expertise at intermediate to advanced level.

My question is about Zero out views. I have a process that has a a zero out view. The data that I am trying to zero out is just base level data. I checked the usual if there was rule, consolidation etc and its just flat data that should clear out. when i run the process I see the record counts but the data doesn't clear. When I try clearing the data using the spread it clears just fine. Very Strange and Scary

Has anyone seen this before. Please let me know. Thanks.

There must be something which you are missing or not doing correctly.

Please read the following post and try to attach the TI Process here so that someone can have a look at it.

http://forums.olapforums.com/viewtopic.php?f=3&t=1037

Are you using the viewzeroout function? If so, then how are you getting record counts.

If you are looping through the view to get record counts, then are you assigning a blank or 0 value to all cells on the data tab?

Thanks for the feed back Gentlemen. I have been tied up with production and couldn't respond. I will look into you recommendation and try to follow. Thanks.