TM1 Forum

Posted: **Sat Oct 08, 2022 3:58 am**

Hi,

I got the idea how to do a Asymetric table and i can now make all the table that i want.

But i want to know how i can keep this Asymetric table while i change to vizualisation view?

I did it 1 time with succes but i dont understand why, how and now, i can not make it again.

Example: i have a Asymetric table

: asymetric table.png (55.83 KiB) Viewed 659 times

I want to do a vizualisation Asymetric (i dont know how i did this) => only 4 colums that i need is showed on the charts

: what vizualisation that i want .png (30.73 KiB) Viewed 656 times

then now, when i try again, i only got something all element is showed on the charts

: what i can do right now.png (44.08 KiB) Viewed 656 times

thank you for all help !!

Cross posted in IBM Community

https://community.ibm.com/community/use ... 4eda43146b

Posted: **Mon Oct 10, 2022 7:46 am**

update : reponse from IBM community

Hi Duong,
You should be able to work either with set editor or with the Fields/Properties to get the results you need.

Check the visualization where you got that was needed and apply similar fields or sets/ hide totals on the next vis.
The flexibility of those area should enable you to get the good results,

TM1 Forum

Asymetric view - vizualisation

Asymetric view - vizualisation

Re: Asymetric view - vizualisation