TM1 Forum

Hi everyone,
I need to run a TI process opening an approval hierarchy node (the ENTER workflow action).

Unfortunately this features:
- is documented in the IBM Knowledge Center (http://www-01.ibm.com/support/knowledge ... ml?lang=en)
- this action is present in the }tmp_workflow_action dimension of the cube }tmp_workflow_action_TI that stores this kind of information
BUT the TM1 Performance Modeler interface DON'T SHOW THIS ACTION TO SET-UP THE PROCESS (also don't show the action LEAVE)

Inserting manually the values in the }tmp_workflow_action_TI cube doesn't produce any effects.

Does any other experimenting this problem? Any suggestion?

My environment is TM1 10.2.2.1

Thankyou in advance and best regards.
Ottavio

Please check the following page from IBM: http://www-01.ibm.com/support/docview.w ... wg1PI16592
While they state that you should upgrade to 10.2.2 FP1 I have to tell you that my installation of 10.2.2 FP2 is not showing the options either..
Maybe they will be back in 10.2.2 FP3, scheduled for release this month!

Dear pandinus,
thank you for your prompt and effective reply.

I will wait for next FP3.

Best Regards
Ottavio

Hi,

it's a pretty old post but I also run in this problem. I have 10.2.2 with FP7 installed. Even than I don't have this option. Does anyone has something like a workaround?

Thx and best regards,
Willi