Hi everyone!
I am facing a problem using the link on Performance Modeler. After all links done I don't see the numbers of source cube on destination cube.
Does anybody know what can be the problem?
Find attached an image where is possible to see the link done on Modeler.
Thanks in advance.
JR
Using Link on Performance Modeler
-
Jorge Rachid
- Posts: 113
- Joined: Fri Jul 22, 2016 8:33 pm
- OLAP Product: TM1
- Version: 10.2
- Excel Version: 2013
Using Link on Performance Modeler
- Attachments
-
- image2.jpg (29.93 KiB) Viewed 3152 times
-
Elessar
- Community Contributor
- Posts: 413
- Joined: Mon Nov 21, 2011 12:33 pm
- OLAP Product: PA 2
- Version: 2.0.9
- Excel Version: 2016
- Contact:
Re: Using Link on Performance Modeler
Hi Jorge,
1. Close the Performance Modeler;
2. Open TM1 Architect;
3. Open the rule generated by Performance Modeler;
4. Delete the generated rule and write the correct one.
1. Close the Performance Modeler;
2. Open TM1 Architect;
3. Open the rule generated by Performance Modeler;
4. Delete the generated rule and write the correct one.
-
lotsaram
- MVP
- Posts: 3704
- Joined: Fri Mar 13, 2009 11:14 am
- OLAP Product: TableManager1
- Version: PA 2.0.x
- Excel Version: Office 365
- Location: Switzerland
Re: Using Link on Performance Modeler
+1Elessar wrote:Hi Jorge,
1. Close the Performance Modeler;
2. Open TM1 Architect;
3. Open the rule generated by Performance Modeler;
4. Delete the generated rule and write the correct one.
Please place all requests for help in a public thread. I will not answer PMs requesting assistance.
-
Jorge Rachid
- Posts: 113
- Joined: Fri Jul 22, 2016 8:33 pm
- OLAP Product: TM1
- Version: 10.2
- Excel Version: 2013
Re: Using Link on Performance Modeler
Hi everyone!
Thanks for the answer.
In this case I did the destination cube again and it works!
This case it would be hard to write the rule because I was using a picklist on metrics dimension and performance modeler give me a easier way that writing rules.
Bye!
Thanks for the answer.
In this case I did the destination cube again and it works!
This case it would be hard to write the rule because I was using a picklist on metrics dimension and performance modeler give me a easier way that writing rules.
Bye!